The nito here is that now both head have different scaling in ZB. If a file says that a mesh is 10 units wide, and it is imported into a program with an internal space measurement set to mm, then that file will be 10mm wide when imported.
I know that at this point I can basically work in RC and do what I need to do but this whole thing where it feels a little bit like lottery whenever I import a retopoed mesh, just feels wrong to me and I would love to be able to nail it down and know what s happening. With no problem� I even closed the scene and re opened it because I wanted to see if I modify the retopo one and save it again, will I be able to import it properly? Now� I managed to import a retopoed mesh and even texture it and all� But there is something very strange happening. The kicker is that the broken one was saved only 5 minutes after the last unbroken one, and the only difference between the two files is some minor detailing on the highest subdiv level, on the knuckles. Though I would expect GoZ to do so I'm on max , as that I decided to stop throwing money down that hole, and so am not supported.
